castings

They are attached to each other and the ship via some mechanism that interacts with their corner castings.

Casting, probably not, but maybe the process can be applied to castings later as a heat-treating step.

This is why machine tools have giant castings well in excess of the strength needed for the machine to stay together.

Or do you have to buy raw ingots and turn those into billets or castings?

I would imagine it is not a one piece casting, so are a few smaller castings bolted together?

We shot ourselves in the foot by paying for tooling for castings before we'd validated it beyond 3d prints.

I used it to melt aluminum and make castings in sand, and it was tons of fun.

Some movies are not well distributed and it appears so that a lot of these movies are from or with an African descent castings.

Most dropped kerbs are simple tarmac ramps rather than concrete castings here.

Tesla was the first to try and build a car that way, they made whole cemeteries of failed castings to prove it out, and now the rest of the industry is buying the machines too.

Drive the price down even further (to say below what it costs to mass produce castings) and you're looking at something where even the imagination will fail.

Our clients can use our API, run castings, etc.

The real deal is this: to get around US firearms laws, there's a mini-industry selling AR-15 "80% lower receivers".[1] These are sometimes advertised as "billets", but they're not unfinished castings.

(Ken Thompson called this effect as "Poor man classes") Macros can be handy when you need to hide this nasty castings away when not using the plan9 extension..

Most products for the time being(once through the DFM process) will still get produced using traditional methods (Injection Mouldings, Castings, etc).

Castings would be ok in some circumstances though the interior cores could be a pain to control, eg: ensuring the sand to create the voids is solid enough not to disentigrate as you try to cast and is not just floating in mid-air.